found the method given by the teacher to draw custom lines, but the method seems to be to draw a frame for a single component, is there any way to frame multiple components?
suppose my model as a whole is a building as follows
and I just want to frame one of the layers, what should I do?
A blog Custom Window Selection in the Forge Viewer that can operate Philippe consists of three
blog address first https://forge.autodesk.com/bl. second https://forge.autodesk.com/bl. third https://forge.autodesk.com/bl.
check the naming rules of a layer in the local viewer api. Then use the search method to traverse the dbid to select a floor
suggestion can refer to teacher Liang's blog https://forge.autodesk.com/bl., it will be easier to understand the box selection, but at the same time, it is also noted that this scheme, including the Philippe scheme, has some limitations. For example, it is not good to support the components of OMagol and U type.
when using three.js, use raycaster to select objects. If there is div occlusion on the upper layer of the canvas, the mouse can still select the model in the canvas. If you want to select a model that is not available when there is div occlusion, how to ...
the doors in the model are like the right side, and there are two modes of opening and closing at the same time. through the setting of the revit property, you can display open (left door), close and simultaneously open (right door) , but after importe...
Autodesk-forge model slightly how to load this model in IE browsers? at present, only advanced browsers such as Crome Google are supported ...
1. The official has the function of viewing the file tree, that is, the file tree of the model browser. What is the api for getting this file tree? ...
as shown in figure is the angle as shown in the picture? ...
A grid function needs to be added to the recent project. Refer to the grid effect done by others as follows: when the mouse hovers over a circle or a straight line, a label prompts : demothree.jsthis.viewer.impl.scenehtmlcanvas ...
I want to load the model locally. The model file is transferred to https: extract.autodesk.io. , it can be run on node.js, but failed to load on .net. The address of the file is not wrong, could you tell me what s going on? "` var initOptions = ...
if you want to customize the capture point of the model by customizing an extension instead of opening the measurement, how can you implement it? ...